ESH 20/40 electric heater
The ESH 20/40 Fan assisted heater is designed for applications that need a large amount of electrical heating. The unit is only available in a 3 phase 415 volt version. The high pressure, high capacity fan enables the ESH 20/40 to deliver 2,266 cfm of heat through ducting of up to 15 meters in length.
What's it ideal for?
| Offices | Building sites |
| Shops and Showrooms | Marquees and tents |
| Hotels | Storerooms |
| Garages | Workshops |
| Industrial units | Clinics |
| Classrooms |
For spaces big or small?
The CT 80 will warm an area of 483 m3 - 17,060 ft3
The CT 80 dimensions are 515 x 980 x 480mm and weighs 28kg
What's so good about it?
| Double skin construction | Quiet in operation |
| Easy installation | Economical |
| Fully portable | Very robust |
| Delivers huge volumes of warm air | Very reliable |
Specification
| Nominal heating duty | 40 kW 136,480 btu |
| Air flow (max) | 3,851 m³/h |
| Typical heated area | 966 m³ |
| Power supply | 415 V 3 ph + E 50 Hz Run 64 A |
| Plug type | BS4343 125 A 4 pin |
| Generator | 60 kVA |
| Noise level (max) | 98.6 dBA @ 1 metre |
| Weight | 93 kg |
| Dimensions (L x W x H) | 950 x 720 x 790 mm |
| Duct length (max) | 15 metres |
| Duct size | 450 mm |
| Control | Manual (Plug in thermostat available) |
| Average power consumption | 40 kW/hr |